Jump to content

Recommended Posts

I've never seen the white turn signal housing sold separately. If you didn't want to buy the whole assy, you might be able to get some 3/8" hard line (or whatever size has the proper ID), cut off a short section and JBWeld it around the broken piece to reinforce it. I measured the OD of the (2) white stubs at around .278".

Link to post
Share on other sites

I think I would try to fill the crack with glue by expanding it with the screw, then remove the screw and put a small clamp on it. If that doesn't hold, fill the holes with epoxy, then drill small pilot holes and use smaller screws with washers to fasten the lenses. Only costs a bit of time and glue to see if it works.

Link to post
Share on other sites

The wife came up with the solution using super glue and the stuff woman use to fix their nails.

It is like a thin cloth that she cut into two thin strips, wrapped around the screw threads which in turn reinforces the whole screw thread.

 

Seems to have work a treat (-:

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...