Jump to content

Recommended Posts

I'm installing 3-point seat belts in my Lotus 7 replica, and need to have any input on how high the shoulder belt anchorage should be above the floor or seat. I'm seeing around 35 inches for production vehicles, so I need recommendations for putting a 1/2" bolt through 1 1/2" roll bar tubing without kinking, crushing, or weakening the roll bar integrity.

Link to post
Share on other sites

 

For reference, with the DOT 3 point belts in a Caterham , the shoulder anchorage was installed at the base of the roll bar on the chassis.  Photo below - ignore the race harness, the DOT belt is the one right next to the roll bar base and tonneau.  This may be high enough for a shoulder as that rear firewall part of the Caterham chassis frame is high enough relative to shoulder height once seated.  

 

 

DSC00015 (1).jpg

 

 

 

If that positioning is ruled out in your car because it is not high enough, then back to your question of drilling the tube, I have always seen the hole sleeved with a metal spacer with the bolt running through the inside of the spacer so that it takes the compression weight rather than the hollow roll bar tube.  

 

 

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...