Jump to content

Alignment; tricky to find specialist?


Recommended Posts

Long story short, I hit a really big pothole at sufficient speed to break a wheel. 

 

I'm on my way to replacing the wheel with the help of Josh at Rocky Mountain Caterham. It seems like a good idea to get the alignment checked. Do I need a special shop/special equipment for that or would a regular alignment shop be able to do it?

 

I'm in western NC

Link to comment
Share on other sites

A competent regular shop can do it, there are lots around that are not, particularly the high street ones so make sure you trust them. I had my whole suspension tuned by a Porsche service center during initial setup after the build as they have some top quality tools and equipment (toe, camber, corner weights, etc). After that I purchased the tools to do it myself. If your just talking toe then this will do the trick...

Tenhulzen 3300 Tenhulzen Two-Wheel Alignment Systems with Toe Plates | Summit Racing

...it's basic but does the job. There are tons of others too.

Link to comment
Share on other sites

Look for a quality alignment or race workshop and ask them to also corner weight the car at the same time.  Someone who works on setting up open wheeler race cars (e.g. Formula Ford) will know their stuff.  

 

 

Link to comment
Share on other sites

Here are some pics when my suspension was set up, including corner weighting. The work was done at the world headquarters of Rocky Mountain Caterham by Nathan Down, former Caterham Engineer and still Formula Ford driver, builder and coach. As a point of reference for the weight, the car is a 2020 420R, with leather seats, windshield motor delete, no heater and track day roll bar

Jim

1280 lbs without driver.jpg

Corner weighting.jpg

Suspension set up front.jpg

Suspension set up rear.jpg

Link to comment
Share on other sites

11 hours ago, kayentaskier said:

Here are some pics when my suspension was set up, including corner weighting. The work was done at the world headquarters of Rocky Mountain Caterham by Nathan Down, former Caterham Engineer and still Formula Ford driver, builder and coach. As a point of reference for the weight, the car is a 2020 420R, with leather seats, windshield motor delete, no heater and track day roll bar

Jim

1280 lbs without driver.jpg

Corner weighting.jpg

Suspension set up front.jpg

Suspension set up rear.jpg

Edit: WINDSHIELD WIPER MOTOR delete. Not sure what these weigh, but not in sequential 

Link to comment
Share on other sites

On 5/8/2021 at 4:52 PM, Croc said:

Look for a quality alignment or race workshop and ask them to also corner weight the car at the same time.  Someone who works on setting up open wheeler race cars (e.g. Formula Ford) will know their stuff.  

 

 

Croc is correct. You want someone who is familiar with racing and preferably open wheel or sports racers. I have never had good luck with commercial shops even ones that specialize in high performance work.   

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...