ratchet

2024 Caterham 620R. S3. NOT SV(large chasis) The ultimate in high performance Caterham Super 7s. 1200 miles. not tracked. Equipped with 310BHP supercharged motor. Dry sumped motor, huge radiator, oil cooler. Oil cooler for the supercharger and intercooler. 6 Speed Sadev sequential gearbox. Aluminum Bilstein race shocks. Aero front wishbones. 4 piston front calipers with vented discs. Track day exhaust system. Carbon vinyl boot cover.Clear lens pack. Full weather equipment. Vintage Green with Luminous Yellow stripes. Carbon fiber front and rear fenders. Carbon fiber seats with padding. Options include: Heater, Plumbed in fire suppression system, Quick release Momo steering wheel, track day roll bar, LED headlamps, battery master switch, map pocket. Caterham factory Indoor and out door covers. The car is perfect and like new inside and out. New Aluma 14 foot tilt trailer. chassis number: 77105. This is the last Caterham built for the USA at the old Dartford factory so a very historic car. The car is titled in Oregon as 1957 Caterham. This car is RHD. 620s are only suppled in RHD. $86,000. Car can be sold without trailer.

A complete Watts linkage kit for LH and RH. This is for metric chassis. S3 or SV. Might be adapted to imperial cars. $600 plus shiping

SOLD

New Brooklands Screens. One has a very faint scratch noted on the picture. Mounting brackets included. $200 per pair plus shipping.

Lower floors. New car take offs. Unused. Left and right. Original Caterham parts. These only fit S3 metric chassis cars unless you are willing to do some modifications. Powered painted black on both sides. Will sell separately if you want to do only one side. $195 each plus shipping.

YES

Used. Very good condition. $75 plus shipping

Factory K Series Header. Very good condition. $65 plus shipping

These have been sold

New set of front and rear CSR shocks/springs. They fit ONLY CSRs. Not applicable to any other Caterham without doing some mods. $910

NOW SOLD

Caterham K Series Apollo tank kit. New. $190 plus shipping.

Lowered floor panels. Right hand and left hand. Metric cars. Including center tube brackets. S3 only. New car take offs. $200 each plus shipping.

Caterham AP 2 pot rear caliper kit. New. Including Pagid pad set. Would need race ears and discs to complete. $500 plus shipping.

All the butterfly's should be open the same amount. And unfortunately that will be accomplished from the linkage underneath. It should have been done by TWM way back. If it's too far off, you may need to remove the assembly and do it on the bench. Later TWM throttle bodies have air bleed screws that allow minute fine tuning. But cap off the vac ports first. Not needed in this application. Those open ports are a big leak.