Lancefitzgiben Posted September 24, 2023 Share Posted September 24, 2023 Does anyone know the proper metric size of o-ring used to seal the finger filter on raceline dry sump'd Duratecs? I fuss around with this every time I change the oil but I'm usually not sourcing metric o-rings, and the fit can be less than ideal. This time around I didn't nail it and I'll have to drain the oil to put in a better fitting o-ring. Any input is much appreciated Link to comment Share on other sites More sharing options...
JohnCh Posted September 26, 2023 Share Posted September 26, 2023 I had the same question so asked Raceline this morning. Peter said it's 22mm x 2mm. 1 Link to comment Share on other sites More sharing options...
Lancefitzgiben Posted September 29, 2023 Author Share Posted September 29, 2023 Do you know if that's 22mm ID or OD? I'm guessing ID. Thank you! Link to comment Share on other sites More sharing options...
JohnCh Posted September 29, 2023 Share Posted September 29, 2023 ID Link to comment Share on other sites More sharing options...
Lancefitzgiben Posted September 30, 2023 Author Share Posted September 30, 2023 Thanks John! I'll order up a pack from McMaster. Link to comment Share on other sites More sharing options...
JohnCh Posted September 30, 2023 Share Posted September 30, 2023 @ashyers brought this place to my attention a few years ago. Huge array of O-rings: https://www.theoringstore.com/store/ -John Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now