Two questions about Caterham steering column

[slngsht]

1. What's the 3 bolt pattern on the steering wheel holes? i.e. what's the diameter of the hole pattern?

2. Anyone have a picture of the 2 bushing supports for the upper steering column? One bushing is right on the lower dash tube... looking for what the other one looks like.

 

Thanks.

[scannon]

Mazda,

 

The three holes are 44mm center to center, I can't remember enough geometry to figure out the bolt circle.

 

Here are some pictures of the supports and a bushing.

[yellowss7]

Mazda, I have a Momo wheel, that was undrilled and was mated to a quick release column, that was drilled. My screws are mounted at 1 3/4 inch apart from each other. There are 3 of them evenly spaced. Hope that helps.

 

I remember the bush in the front of the dash, as a white one with 2 little tabs on it. I can't recall installing the rear most bush. I think it may have been premounted at the factory. I could be wrong in my recollection though, that was 10 or 11 years ago.

 

Tom

[slngsht]

Perfect Skip. Just what I needed. Thank you.

 

BTW, this little tool is handy: http://ostermiller.org/calc/triangle.html

 

pattern radius is 25mm. I'll try it on the CNC router and see how it works out