Free Pectel SW, Interface and laptop

[kayentaskier]

Two years ago, I was a member here under the name kayentaut. At that time, I was having intermittent stalling issues with my Zetec with Pectel ECU. Member catsv7 was very helpful is spec’ing the required cables and sending me the Descpro(w) software. I purchased an old Windows 95 laptop to run the SW. I no longer have the car, but after reading Vovchandr’s post about poor mileage, I thought about the laptop, cables and SW. In the end I never used this, so no guarantee it even works.

 

If anyone has use for this, I would be happy to send it to you, all you need to do is pay shipping from San Francisco.

Jim

[Vovchandr]

Jim,

 

That is a very generous offer to the members.

 

I just got my cable in this week and as a matter a fact it's sitting next to me in the office waiting to be installed.

 

Hopefully I don't have any Deskpro compatibility issues but since Murphy is always around, I'm not being optimistic.

 

 

 

Over the next few weeks worst case scenario I might have to take you up on this offer myself and then repost the offer once I'm done with it and have everything set on my end to help somebody else.

Edited May 19, 2019 by Vovchandr

[kayentaskier]

OK let me know, if someone else needs it, perhaps it can just be passed around as needed.

[Slonie]

OK let me know, if someone else needs it, perhaps it can just be passed around as needed.

 

Thanks for the generous offer! I am not in a position to actually take advantage right this moment, but since I have the car with a Pectel, I've always thought about acquiring the requisite setup to at least read and back-up my map. So I've got an eye on this thread to see where it ends up...

[kayentaskier]

Vadimir has decided he needs to use the set up, so it will be sent to him in the next couple of days. In a PM to me he suggested the idea of archiving the Descrow SW to a site that others could access. Not sure if this is possible on this forum or if it would need to be someplace else.

Jim