Double Ended Stud

[tyebbvs8]

Hey All,

 

I need to source a replacement 7/16 UNF x 8 inch long double threaded stud for my Westfield Miata - It is to connect my rear Knuckle to the lower control arm.  Does anyone know where to get one? or have one made?

 

Its to replace this one that I had to cut in half to remove it.

[Alex-Ks1]

Try , Carr Mc Master out let, they have anything in the nut and bolt world . I use them a lot 

[MV8]

You could use high strength threaded rod or a setup stud (both from Mcmaster). I assume the actual miata metric bolt is too long to be used with the westy control arm.

[Christopher smith]

If anyone needs metric fasteners I keep hearing from Bel-metric who may have a large stock

[Timothy Keith-Lucas]

McMaster-Carr at mcmaster.com  I'll go looking in a minute.

[Timothy Keith-Lucas]

Here go:

https://www.mcmaster.com/products/threaded-rods/threaded-rods-1~~/threaded-rods-3~performance~high-pressure/

 

If that's not right for you back up a bit in McMaster-Carr and go down a different branch. Their catalog lets you start with something like "fastener" and go through choice points until you find what you want or that it it not manufactured.

[JohnCh]

FYI the original poster attempted to scam several people here and his multiple accounts have been banned.