General Tech

2,347 topics in this forum

1. Water temp sensor - help with identifying?

   By patience, February 9, 2016
   • 9 replies
   • 3.5k views
   • 
   • Off Road SHO
   • February 28, 2016

2. Haltech fuel map

   By Guest Silverspur, February 26, 2016
   • 2 replies
   • 1.3k views
   • 
   • Guest
   • February 26, 2016

3. GPS Lap Timer system? 1 2

   By SK400, February 14, 2016
   • 20 replies
   • 8.7k views
   • 
   • Sean
   • February 19, 2016

4. Help! Wcm Qa1 8243 shock rebuild

   By wcmgoldie, February 18, 2016
   • 4 replies
   • 2k views
   • 
   • wcmgoldie
   • February 19, 2016

5. Braille battery post shield

   By papak, February 18, 2016
   • 3 replies
   • 2.1k views
   • 
   • tomatva
   • February 19, 2016

6. Wiring harness

   By papak, February 15, 2016
   • 5 replies
   • 3.1k views
   • 
   • papak
   • February 16, 2016

7. Why am I getting so many exhaust fumes? 1 2 3

   By traveler501, December 7, 2015
   • 43 replies
   • 16.9k views
   • 
   • Off Road SHO
   • February 13, 2016

8. R 500 change from BOB STARTER to Key or Push Button.

   By redgoose, February 2, 2016
   • 7 replies
   • 3k views
   • 
   • Croc
   • February 6, 2016

9. Oil Filter Housing, Brunton Stalker V6

   By comley, February 4, 2016
   • 0 replies
   • 948 views
   • 
   • comley
   • February 4, 2016

10. Dry sump routing, tank to valve cover or not? Where to put the cooler?

    By TurboWood, January 23, 2016
    • 2 replies
    • 1.8k views
    • 
    • TurboWood
    • January 24, 2016

11. December 31st was a bad day....

    By TwedleJoe, January 18, 2016
    • 3 replies
    • 1.8k views
    • 
    • TwedleJoe
    • January 19, 2016

12. Wcm ultralight replacement seat?

    By wcmgoldie, January 4, 2016
    • 4 replies
    • 2.2k views
    • 
    • powderbrake
    • January 5, 2016

13. HELP!!......Clutch release bearing set up

    By jvbtte, April 24, 2009
    • 11 replies
    • 4.6k views
    • 
    • climber
    • January 3, 2016

14. Genuine FORD parts Supplier

    By MichaelD, July 23, 2015
    • 7 replies
    • 3.8k views
    • 
    • traveler501
    • January 2, 2016

15. Which loom to use for zetec svt to csr260 duratec conversion in s3 chassis??

    By vstryker, December 22, 2015
    • 6 replies
    • 2.7k views
    • 
    • Sean
    • January 2, 2016

16. Old Tech and Theories That Still Apply

    By xcarguy, December 27, 2015
    • 1 reply
    • 1.2k views
    • 
    • NVP66S
    • December 27, 2015

17. To everyone with a Kent Crossflow engine

    By MudHut, December 3, 2015
    • 9 replies
    • 3.8k views
    • 
    • MudHut
    • December 14, 2015

18. Muffler for C-7 with Race Spec Kent Crossflow Engine

    By O Racer, November 13, 2015
    • 9 replies
    • 4.6k views
    • 
    • O Racer
    • December 13, 2015

19. A2 camshaft question

    By coffee break, December 11, 2015
    • 2 replies
    • 1.8k views
    • 
    • The Stig
    • December 11, 2015

20. Working kinks out of a new build - engine idle and grinding noise from rear

    By frizille, August 3, 2015
    • 12 replies
    • 5.9k views
    • 
    • frizille
    • December 7, 2015

21. Removing oil pan

    By frizille, October 1, 2015
    • 7 replies
    • 2.5k views
    • 
    • frizille
    • December 7, 2015

22. Riveting Question

    By Cranky, November 30, 2015
    • 3 replies
    • 1.7k views
    • 
    • FE07
    • December 1, 2015

23. Help with 1700cc heater plumbing

    By GCarlson, November 30, 2015
    • 0 replies
    • 850 views
    • 
    • GCarlson
    • November 30, 2015

24. Front wheel bearing question

    By coffee break, November 10, 2015
    • 8 replies
    • 2.5k views
    • 
    • DeanG
    • November 12, 2015

25. Instruments in Westfield panel

    By NVP66S, September 19, 2015
    • 4 replies
    • 2.2k views
    • 
    • MPG
    • November 10, 2015