General Tech

2,387 topics in this forum

1. Dry sump routing, tank to valve cover or not? Where to put the cooler?

   By TurboWood, January 23, 2016
   • 2 replies
   • 2k views
   • 
   • TurboWood
   • January 24, 2016

2. December 31st was a bad day....

   By TwedleJoe, January 18, 2016
   • 3 replies
   • 2.1k views
   • 
   • TwedleJoe
   • January 19, 2016

3. Wcm ultralight replacement seat?

   By wcmgoldie, January 4, 2016
   • 4 replies
   • 2.4k views
   • 
   • powderbrake
   • January 5, 2016

4. HELP!!......Clutch release bearing set up

   By jvbtte, April 24, 2009
   • 11 replies
   • 4.9k views
   • 
   • climber
   • January 3, 2016

5. Genuine FORD parts Supplier

   By MichaelD, July 23, 2015
   • 7 replies
   • 4.3k views
   • 
   • traveler501
   • January 2, 2016

6. Which loom to use for zetec svt to csr260 duratec conversion in s3 chassis??

   By vstryker, December 22, 2015
   • 6 replies
   • 2.9k views
   • 
   • Sean
   • January 2, 2016

7. Old Tech and Theories That Still Apply

   By xcarguy, December 27, 2015
   • 1 reply
   • 1.4k views
   • 
   • NVP66S
   • December 27, 2015

8. To everyone with a Kent Crossflow engine

   By MudHut, December 3, 2015
   • 9 replies
   • 4.2k views
   • 
   • MudHut
   • December 14, 2015

9. Muffler for C-7 with Race Spec Kent Crossflow Engine

   By O Racer, November 13, 2015
   • 9 replies
   • 4.8k views
   • 
   • O Racer
   • December 13, 2015

10. A2 camshaft question

    By coffee break, December 11, 2015
    • 2 replies
    • 2k views
    • 
    • The Stig
    • December 11, 2015

11. Working kinks out of a new build - engine idle and grinding noise from rear

    By frizille, August 3, 2015
    • 12 replies
    • 6.2k views
    • 
    • frizille
    • December 7, 2015

12. Removing oil pan

    By frizille, October 1, 2015
    • 7 replies
    • 2.8k views
    • 
    • frizille
    • December 7, 2015

13. Riveting Question

    By Cranky, November 30, 2015
    • 3 replies
    • 1.9k views
    • 
    • FE07
    • December 1, 2015

14. Help with 1700cc heater plumbing

    By GCarlson, November 30, 2015
    • 0 replies
    • 1k views
    • 
    • GCarlson
    • November 30, 2015

15. Front wheel bearing question

    By coffee break, November 10, 2015
    • 8 replies
    • 2.8k views
    • 
    • DeanG
    • November 12, 2015

16. Instruments in Westfield panel

    By NVP66S, September 19, 2015
    • 4 replies
    • 2.4k views
    • 
    • MPG
    • November 10, 2015

17. R400 Start Up Problem

    By TwedleJoe, October 15, 2015
    • 12 replies
    • 6.1k views
    • 
    • BruceBe
    • November 3, 2015

18. Shocks lenght ??

    By gregprelit, October 19, 2015
    • 0 replies
    • 762 views
    • 
    • gregprelit
    • October 19, 2015

19. USA Bulbs Re-visited

    By Bonjo2, October 17, 2015
    • 0 replies
    • 1.3k views
    • 
    • Bonjo2
    • October 17, 2015

20. Electrical switches

    By papak, October 15, 2015
    • 3 replies
    • 2k views
    • 
    • maurice1
    • October 16, 2015

21. Pulling the head on a 2.3L duratec

    By yellowss7, September 7, 2015
    • 16 replies
    • 6.6k views
    • 
    • yellowss7
    • October 14, 2015

22. Type 9 Gearbox Reference

    By slngsht, November 18, 2006
    • 5 replies
    • 4.1k views
    • 
    • MichaelD
    • September 30, 2015

23. Fuel problem

    By wemtd, September 26, 2015
    • 3 replies
    • 2k views
    • 
    • BusaNostra
    • September 28, 2015

24. Steering Wheel Alignment

    By kayentaut, September 22, 2015
    • 6 replies
    • 3.4k views
    • 
    • drew...
    • September 23, 2015

25. Zetec SVT parts needed

    By Kitcat, September 21, 2015
    • 2 replies
    • 1.6k views
    • 
    • slomove
    • September 21, 2015