General Tech

2,346 topics in this forum

1. Shake/vibration at speed

   By yellowss7, September 9, 2013
   • 17 replies
   • 3.7k views
   • 
   • yellowss7
   • September 14, 2013

2. Interesting problem solved

   By ultraslow, September 6, 2013
   • 1 reply
   • 1.3k views
   • 
   • CASwede
   • September 13, 2013

3. Video / Data Logging

   By jeffs, August 2, 2013
   • 5 replies
   • 3.1k views
   • 
   • jeffs
   • September 12, 2013

4. High level brake light

   By Red Duck, September 11, 2013
   • 4 replies
   • 1.8k views
   • 
   • rx7locost
   • September 12, 2013

5. WCM hood scissor hinges, where do I get them?

   By wcmgoldie, September 11, 2013
   • 2 replies
   • 1.3k views
   • 
   • rss
   • September 12, 2013

6. Corner weighting r300

   By Klasik-69, August 26, 2013
   • 11 replies
   • 4.1k views
   • 
   • JBH
   • September 11, 2013

7. bad caterham dash wiring plug

   By twobone, September 8, 2013
   • 2 replies
   • 2.6k views
   • 
   • 11Budlite
   • September 9, 2013

8. need external fuel pump for honda s2000 motor

   By Bruce K, July 8, 2013
   • 16 replies
   • 4.8k views
   • 
   • 11Budlite
   • September 9, 2013

9. BGH vs. SPC?

   By TurboWood, August 23, 2013
   • 6 replies
   • 3.4k views
   • 
   • maurice1
   • September 3, 2013

10. Weber runs fine on main jets but is tough to start and bogs off idle

    By twobone, August 29, 2013
    • 2 replies
    • 2.2k views
    • 
    • TheDingo8MyBaby
    • August 30, 2013

11. Stall then failed hot start

    By DeanG, July 21, 2013
    • 8 replies
    • 2.4k views
    • 
    • Kitcat
    • August 24, 2013

12. Race Clutch for 220 hp Zetec/T-9

    By MichaelD, August 20, 2013
    • 1 reply
    • 8.7k views
    • 
    • blubarisax
    • August 21, 2013

13. toe gauge recommendations?

    By rss, August 16, 2013
    • 11 replies
    • 3.8k views
    • 
    • Kitcat
    • August 19, 2013

14. Wheel Alignment for Radial Slicks on Track Caterham

    By blubarisax, August 13, 2013
    • 9 replies
    • 4.3k views
    • 
    • blubarisax
    • August 15, 2013

15. Sierra Differential Venting

    By Klasik-69, August 7, 2013
    • 6 replies
    • 2.1k views
    • 
    • Klasik-69
    • August 11, 2013

16. Cam & lifter inspection on a 1700 Kent

    By whotoo, August 9, 2013
    • 2 replies
    • 1.8k views
    • 
    • BMW RACER
    • August 10, 2013

17. Duratec Oil Coolers

    By a.moore, June 16, 2013
    • 11 replies
    • 5.2k views
    • 
    • a.moore
    • August 8, 2013

18. S3 Brake Master Cylinder

    By ultraslow, August 6, 2013
    • 4 replies
    • 2.9k views
    • 
    • Jackal
    • August 7, 2013

19. Roll bar diameter on WCM?

    By wcmgoldie, August 5, 2013
    • 5 replies
    • 7.6k views
    • 
    • jlumba81
    • August 5, 2013

20. How to cut a hole in the bonnet

    By boss351, July 20, 2013
    • 13 replies
    • 3.9k views
    • 
    • boss351
    • August 5, 2013

21. Wheelbearing failure

    By Kitcat, July 28, 2013
    • 11 replies
    • 3.4k views
    • 
    • Kitcat
    • August 2, 2013

22. Duratec Dimensions?

    By TurboWood, July 28, 2013
    • 6 replies
    • 10.1k views
    • 
    • TurboWood
    • July 31, 2013

23. Switch to SBD Motorsports tapered throttle bodies

    By boss351, July 28, 2013
    • 4 replies
    • 2k views
    • 
    • boss351
    • July 28, 2013

24. Retro Ford Duratec water rail

    By boss351, July 28, 2013
    • 0 replies
    • 1.3k views
    • 
    • boss351
    • July 28, 2013

25. Ford T9 Transmission - serial number location?

    By SCH, July 27, 2013
    • 5 replies
    • 1.9k views
    • 
    • SCH
    • July 28, 2013